|
|
Machine
Shop 4 |
|
|
Machine
Shop 4 |
Advanced Inspection
- Gage Blocks
Please turn into instructor after completing
required operations
| Part # 2A
Part Description: Advanced Inspection - Gage Blocks Quantity Req.: 1 |
Name _________________________
Date: ________________ |
PLEASE HAVE INSTRUCTOR INITIAL AND DATE GREY BOXES (*), AFTER REQUIRED
OPERATIONS
1. Have an instructor fill in the sizes to be used on this sheet.
Determine what blocks should be used for the following dimensions. Do the
math on the back of this sheet, remember to eliminate the last figure to the
right first.
|
|
|
|
2. Using two wear blocks, wring two sets of gage blocks to the following dimensions.
|
|
| Step# | Location | Description | Initials | Date |
| 10 | Inspection Area | Obtain a set of Gage Blocks | ||
| 20 | Inspection Area | Select a Snap Gage. | ||
| 30 | Inspection Area | Have instructor set a go and no-go size for the snap gage. |
Go |
No Go |
| 40 | Inspection Area | Calculate the gage block stack up. Make sure you are using wear blocks. | ||
| 50 | Inspection Area | Select the blocks. Clean the blocks. Wring the blocks together. | ||
| 60 | Inspection Area | Set the snap gage. | ||
| 70 | Inspection Area | Have instructor check settings. | * |
